The front and back of each gutter piece will have 2 holes.
Diy gutter planter.
For your project slide a cross clamp up the suspension wire to the bottom of each gutter segment.
Garden answer youtube.
Using a marker mark your hole marks at 3 inches over and 1 2 inch down see the image 1 bottom of gutter below next drill the holes on the front and back of the gutter.
Repeat threading up through the bottom hole and out through the side hole on the next two left gutter sections.
Start by drilling the bottom holes using your drill and 3 8inch bit.
Then thread the brace piece through the same clamp and tighten it with a screwdriver.
Thread the unknotted end of the rope through one of the holes in the bottom of the left gutter section and then out the.
Tie a knot at one end of the 10 foot rope.
Garden answer youtube.