How to make a scuttle attic a k a.
Diy attic access panel.
Use a straight edge knife to cut any drywall paper that.
Use a pencil and draw a box within the joists.
Using drywall knife start cutting the ceiling out along your line.
Purchase some 2 4 interior door jamb stock from your local building supply centre or any shop that supplies.
Using a stud finder mark your joists.
Most panels don t need to be more than the width of a typical framing bay 14 1 2 in and if you re lucky enough to have the mixing valve fall conveniently between two studs the inner edges of the stud bay.
If you have an attic access panel in your ceiling and are concerned about heat loss don t despair.
First determine the size and location of the access panel and lay out the top and bottom edges of the panel lightly on the drywall.
You ll notice in the photo below that interior door jamb stock does not have any kind of weather stripping in.
Measure and draw the width between the joists and 28 to 30 inches for the length of the panel.
How to make an attic access door.
For some unknown reason attic access doors in older homes are usually through a small scuttle hole cut in the ceiling.
This creates an insulated attic access door.
Use a narrow.
Often the access is in an out of the way place like a closet.
You ll notice in the pictures below that now you.
Stack insulation batts on top of the duct tape so they extend about 1 in.
Attic access panel determine where your joists are.