Cutting the vinyl siding is easy.
Cut hole vinyl siding.
Holes an inch or two across or long narrow holes that still appear patchable require removing the damaged piece of vinyl to fix it.
A siding zip tool pops the piece off from the bottom edge.
Make the line as dark as possible so it s visible when you re cutting it.
Cover the hole from the back side with foil tape then put the siding back where it belongs.
Follow these steps on how to cut vinyl siding with a circular saw.
Make crosscuts on vinyl siding using a circular saw but you should install a vinyl cutting blade to minimize chip out.
The best way to cut vinyl siding circular saw.
You ll need a fine tooth plywood saw blade to do this correctly.
A clean way to cut vinyl siding is to score it with a utility knife and then bend the vinyl at the score.
You can also use tin snips to make crosscuts.
This method is best for cutting a lot of short or long vertical cuts since the circular saw will create clean incisions relatively quickly.
For the smoothest cuts put the blade in.
This is a trick on how to cut vinyl siding the quickest and easiest way without breaking or chipping it.
Place that strip of vinyl siding so that the piece and the line you want to cut are slightly off the.
A hole saw tin snips etc will slice right through it.
I would cut from the outside on top of the vinyl siding not sure where you are if it s too cold outside but the vinyl siding may crack beyond the hole s diameter you are trying to cut it from the inside.
Use a carpenter s square to draw the line straight.
That said the hole is the least of your effort.
Use tin snips or a rotary tool to make curved cuts.
When making longitudinal cuts score with a knife and break along the score line.
The blade you want to use is a general purpose blade that can cut wood metal this will also work on vinyl but be careful regardless of which blade or tool you use if there is too much heat built up on the blade during use the vinyl may melt the vinyl.
Fit a circular saw with a fine toothed plywood cutting blade.
Place a strip of siding on the work table and align the place you plan to cut it with the edge of the table.
Cut a scrap piece of siding to a length that is several inches longer than the hole.
When we cut with a circular saw we often install the blade backwards to minimize ripping and tearing of the vinyl.
Using a circular saw is the first method that you can use to cut vinyl siding.
It should snap apart.
Not just any circular saw blade will do.
First lay a strip of vinyl siding onto a flat and clean working table.
With a pencil and measuring tape mark.
