Curved Column Line Revit Not Seen On Other Floors

To prevent the floor or slab from being visible in plan view you need to adjust the bottom clip so that it is more than 4 feet above the floor or slab and set the view depth so that it does not include any part of the floor or slab.

Curved column line revit not seen on other floors.

See masking regions and filled regions. Ami out of luck or is there some trick i don t know yet. Thank you all kindly. In plan view click view menu view properties.

If not apologies in advance. See override individual lines in an element. If your model in place intersects the cut plane at even just one point it ll show the entire model regardless of whether or not the other parts should be seen. Verify that the element is not hidden by a masking region or a filled region.

If the element is part of a linked file do the following. An even more bizarre example is where a revit floor will disregard your view depth and show anyway as long as it is within an arbitrarily picked range of 4 feet of your bottom clip. In the main floor level the bottom of the primary range is set to main floor with an offset of 1. If you are using slabs with split lines and very steep angles you might want to model those floors as two floors using slap shape points.

I am trying to create a gap in a curved grid line but this seems beyond revit s capabilities. Is your grids workset opened in the project. If the view range intersects the geometry of a level in your main view that level cannot be used as an underlay in the main view. When you tried to underlay a floor only doors and windows were visible.

First post here and i hope i am in the right place. This issue occurs because there is an incorrect view range in the main view. Those floors will be ignored entirely. Structural analytical lines are not centered on columns when grade beams are off center.

Konstru will store split lines and slab shape points but represent the floor outline only. Doubly curved surfaces generated by slab shape points are not supported. The application is working as expected and as designed however a setting change will address this. Ensure the link is loaded.

It follows the below procedure. Verify that your grids workset display yes in the opened column. This is related to the auto detect settings for the column s analytical model and also the tolerances set in structural settings. Ensure the link is visible in the view.

For vertical columns you can derive end points via level parameters and offsets. To see if this is the problem toggle on the reveal hidden elements tool. See unload and reload linked models. A slanted column on the other hand is equipped with a location curve.